Producing casebound books


After hanging the book, place it between two pressing boards. The metal strip on each board should be fitted into the book's hinge.

Place the pressing boards and book assembly into a book press until the paste is completely dry. The pressing operation is shown Figure 10-32. When dry, the book can be removed from between the pressing boards. Clean off the excess glue as required. The book is now complete.
Pressing a book between pressing boards in a book press.

Post a comment
Name: 
Code:  

3 Comment More comments »
Commented by kanth.reddy22@gmail. ip:111.93.17.* 2012-02-25 20:11:40
good
Agree[0Disagree[0]
Commented by bunka ip:84.255.207.* 2009-11-30 05:40:00
Glued book blok is usualy preheated again before goes into rounding machine
Agree[2Disagree[1]
Commented by garyvann ip:98.224.76.* 2009-06-12 15:57:08
In your above instructions on hand bound books, I would think that rounding would occur prior to gluing the back (spine).  If the glue has set how can you then round the front and back?  Do you do the rounding while the glue is drying?     
Agree[2Disagree[2]
©2003-2023 zx-printing.com, ZX China Industrial Ltd. all rights reserved. Terms & conditions.
China: Currency | Unit Converter | Free Fonts | SiteMap | Rss